For the complete documentation index, see llms.txt. This page is also available as Markdown.

Nio Basic Test Jig Setup

Prepared By Lior Jigalo

Connecting SX

  1. Populate SX card with 2x NVME, WiFi, modem and SIM cards.

  2. Connect SX connector to NIO card. Make sure about the following:

    1. SX is laid to the side away from SOM installation.

    2. Insulation (like cardboard or a plastic sheet between SX and NIO.

NIO panel connectors

  1. Connect thumb drive with test image to USB 10G port (lowest one).

  2. Connect USB hub to USB 3.2 gen.

    1. Connect Display Jig USB to DUT

    2. Connect the full size display port from Display Jig to DUT.

    3. Connect 2x mini-Display port from Display Jig to DUT.

    4. Connect hdmi from Display Jig to DUT.

    5. Connect mini-USB cable from the USB hub to the console port (loopback).

  3. Connect a USB-to-Ethernet adapter to USB 3.2 port and insert LAN cable in adapter.

  4. Connect a USB 3.2 gen 2 Thumb drive.

  5. Ensure DC cable is connected to SOM DC-in connector (do not yet connect PSU).

Last updated