For the complete documentation index, see llms.txt. This page is also available as Markdown.

COM7 test preparations

Prepared by Lior Jigalo

Preparing COM DUT

  1. Install two RAM modules on COM

  2. Insert an NVME drive in the NVME slot on the carrier.

  3. Connect DC cord to COM.

    Important: Ensure PSU is disconnected from the test jig!

Preparing COM DUT

  1. Important: Ensure PSU is disconnected from the test jig!

  1. Lower COM DUT onto the carrier.

  2. Press firmly on the COM until you feel the board to board connectors click into place like in the picture below.

  1. Connect PSU

Last updated