Bedrock 3D Model

How to use Bedrock 3D model

• Download Bedrock V3000 3D model (Zipped STEP file) or Bedrock R8000 4X25 3D model (Zipped STEP file)

• or Bedrock R7000 Basic 3D Model (Zipped STEP file)

• Enable one of the enclosure types

  • Enclosure tile

  • Enclosure 30W

  • Enclosure 60W

• Enable / disable Antennas

The 3D model is for integration. It is accurate externally , with no internal features.

Installation notes

See also: Bedrock Mounting options

Orientation

Bedrock 30W and Bedrock 60W should be installed in vertical position with at least 2 cm clearance below and above for airflow.

Other mounting orientation can be considered with active cooling.

Bedrock Tile should have at least one of the walls thermally coupled to a cold plate.

Mounting notes

Rear panel: 2x M3 threadings. Depth 3mm

Rear panel can be used with

• Bedrock wall mounting bracket

• Bedrock DIN rail bracket

• Custom mounting fixture

Bottom panel: 2x M4 threadings, depth 6mm

Bottom panel should not be used for direct mounting, but can be used with Bedrock foot.

Tile: 6x M4 threadings depth 3.5 mm on each wall

The threaded holes are intended for easy attachment to a cold plate for conduction cooling. Either of the walls can be attached at any orientation.

It is also possible to attach using another fixture e.g. a custom omega bracket.

It is advised to apply thermal interface material between wall and cold plate on the entire wall area.